Home
   Models
   New Products
   Slide Show
   Events
   Download
   Hörmann driver
   Distributors
   Contact
   Imprint


 

HT2

The HT2 is completely designed for rigorous racing. Its numerous successes in the D-Cup, as well as in many European races make the HT2 the most sought after RC model on a scale of 1:6. Numerous details of this vehicle are continually being developed further in the areas of longevity and ease of service. The following equipment features set the benchmark in the off-road category:

A stable chassis made from 4mm-thick aluminium with a 510mm wheel base; a front axle made entirely from aluminium; stable control arms with very good adjustment options; a rear axle made entirely in aluminium, with a permanent toe-in; the upper control arm is adjustable.

The aluminium steering stub axles with brake mounting provision allow for installation of all current braking systems. The drive unit with its fixed connection between the clutch shaft, lay shaft and the motor mounting base provides enough stability to pass the power onto the rear axle - even with tuning motors. The very durable delrin main gear, combined with the tempered steel gears, provide the appropriate forward drive.

Further details are the Zenoah G260RC motor with a RN tuning off-road filter, as well as a carbon fibre servo plate for 3 servos. A powerful mechanical transmission brake and a steel ball drive with dust collars.

A muffler made from stainless steel. The smooth running ball bearings, a very stable and durable differential. The almost indestructible rubber spoiler, and the equally robust rims with aluminium reinforcements.

The parts and their materials in detail:

    Aluminium Parts:
  • chassis plate
  • axle supports
  • control arms
  • steering stub axles
  • shock absorber bridge
  • shock absorbers
  • stop pins
  • servosaver bottom section
  • connecting piece for A + B axle support
  • wheel drivers
  • load washer for plastic gear
  • engine flange
  • gearbox flange
  • engine braking plate
  • differential housing
  • differential side panels
  • rear underframe
    Steel Parts:
  • suspension pins
  • steel ball for steering linkage
  • tie rods
  • tempered gears
  • clutch bell
  • stainless steel bow
  • stainless steel muffler
  • drive shafts
  • ball drive
  • full floating axle for ball drive
    Plastic Parts:
  • Spoiler made from special plastic, very flexible
  • spoiler holder side panels
  • front ram bumper
  • side bowl
  • servosaver bottom section
  • plastic joints for the steering
  • main gear made from delrin
  • fuel tank
  • protective collars for the ball drive
  • receiver box
  • rims
  • ccumulator retaining plate
  • carbon fibre servo plate
    Optional Tuning:
  • Hydraulic brakes front / rear axle
  • carbon fibre brake discs
  • engine quickchanger
  • spoiler fastening for rubber spoiler
  • steel wheel drives 9.5mm with pins
  • tie rod retainer
  • retainer for personal transponder
  • check valve for fuel tank ventilation
  • adjustable spoiler holder
  • carbon fibre accumulator retainer
  • tuning muffler


-> up





-> Models / Overview
-> Home




Home    |     Models    |     New Products    |     Events    |     Download     |     Contact    |     Imprint

© 2005 - 2024 HÖRMANN / Internetagentur: synergie-medien-ulm